Overview
FR Skates Brake Mounts and Seba Skate Brake Mounts for their three and four wheel frames. Brake pad included.
3W (110 - 125mm): For 3-Wheel Frames using 110mm and 125mm Wheels
4W (72 - 90mm): For 4-Wheel Frames flat or rockerable
Not compatible with Neo Skate Frames or X3R Frames on 2025 FRX 80, FR3 80 Skates
4W (72 - 90mm) INCLUDING X3R: For 4-Wheel Frames flat or rockerable
Includes X3R Frames used on the 2025 FRX 80 and FR3 80 Skates (also works on the older frame)
Compatible with the NEO2 80
How to Install 3W Brake for FR Frames 3x110 or 3x125:
Includes 2 Axles Threaded at Both Ends and 4 Fastener Screws
Replace the two rear axles on your frame with the two axles supplied with the brake mount.
Slide brake arms over the axles and secure using the four fastener screws.
NOTE: 3D Frame has ridges resulting in the frame arms not being flush against the frame
How to Install on 4W Mount for FR Frames 4x76, 4x80, 4x84, 4x90 (219-273mm):
Includes 2 Regular Axles Threaded at Both Ends, 4 Fastener Screws, 1 Rockerable Brake Axle
Replace the rear axles on your frame with two supplied axles threaded at both ends.
The rockerable brake axle included is extra if not replacing a rockerable axle in the 3rd wheel position on your frame.
Price Includes Mount, Brake Pad, 2-3 Threaded Axles, and 4 Fastening Screws
Previous Feedback
Comments: While the 3 wheel version of this heel brake does technically fit onto the 230mm FR 3D 310 frames found on FR1 310 skates, it's not a great fit. Take a close look at the decorative(?) bumps above each axle on the frame. When mounting with the designated 110m frame hole on the brake, the brake actually sits ON TOP of the bumps of the back wheel. It feels decently snug but doesn't really inspire confidence. Note that the included axles are actually 36mm long compared to the default 34mm long axles on that frame, so they stick out a bit on one side. I'm not sure if this is an oversight or if it was designed this way due to the 110m mounting option floating on top of the bump of the frame... Using the 125mm hole for this scenario is also not an option due to the extra length of the axle which causes the heel brake to be insecure on one side.
From: Will, 9/1/21