Overview
Powerslide MyFit Liner Molding Socks are designed to be used with Heat Moldable Liners to better customize fit during the molding process. The purpose is to roll these socks over the outside of the liners after heating. The compression perfectly customizes fit for a better, more comfortable performing wrap.
- Sold in Pairs
- Sizing Guidelines:
- One Size Fit All
- How to Use:
- Heat liners at 175-185F in an oven for 5-7 minutes.
- With socks on, put feet in liners and slide Molding Socks over them.
- Place your feet (with liners on) inside your boots and lace/buckle all the way.
- Stay seated until liners cool.
- Process May Be Repeated as Needed - DO NOT OVERHEAT LINERS AND BE CAREFUL AROUND HEAT
Specifications
Instructions for Use:
- Remove Footbed from Liner(s)
- See heating instuction that accompanied your liners. Otherwise, MyFit recommends to heat liner(s) for 5-7 Minutes with Hair Dryier or Oven at Appoximately 175 Degrees. Read model specific instruction. DO NOT OVERHEAT or hold too close to material.
- Carefully Test to Make Sure it not Overheated
- Place Footbed Back in Liner(s)
- In a Seated Position - Slip on Liner(s)
- Roll Socks Over Liners Starting at Toe and Stay Seated During Cooling Process
- The Result is a Perfectly Custom Fit Liner
- This Process May Be Repeated as Often as Wanted
