Overview
The Powerslide Hex Skate Tool is a handy-sized tool with a 4mm hex. One should always be with you when skating as you never know when you'll need it to tighten an axle or help remove/replace a wheel and/or bearing.
The size of the tool is light and easy to store and it can even be fastened to the outside of a pack using the loophole on the handle. The skinny nub on the opposite side of the handle is used to pull or push out bearings from wheels. Those with 8mm axles and floating bearing spacers can place this end of the tool in the center of the bearing and carefully work it around to pry the bearing out a little bit at a time. If using 6mm axles and long-sleeved spacers, this same part of the tool will push directly on the spacer to pop the bearing out the other side. By using this tool to remove bearings, you can prevent from damaging bearings and spacers with that screwdriver of yours.
